SAKER
Contour Gauge 10-Inch with Lock
A row of flat plastic teeth that presses against door casings, pipe curves, and uneven baseboards to lock the profile for a pencil trace.
$19.994.6 out of 5 22,735 ratings
Contour Gauge Pair, 10-Inch and 5-Inch
Cutting flooring around a door casing or fitting sheet metal over a curved fender takes patience and a dependable trace. We put two different gauges in this pack so you can take the profile off narrow pipes or wider spans of trim. Press the teeth into the shape, flip the lever, and carry the line over to your plank.
$29.994.6 out of 5 8,120 ratings
Price and stock live with the storefront and can move between visits.
2 versions of this bodySame tool, different kit or size. The spec line on each page carries what changed.
What this one is built to do
Pins hold their place
The locking lever clamps the plastic teeth down after you press the gauge against the molding. The pins stay where you pushed them while you carry the tool over to the plywood.
Adjust the pin tension
Pins slide easily when new and loosen over months of tracing ductwork. We built an adjustment point into the frame so you can tighten the drag on the teeth with a turn of a screw.
Two sizes in one pack
You get a short gauge for tight clearances behind a radiator and a longer one for stair treads or wider baseboards. Both slide into a single bucket or ride flat in a drawer.
Tough plastic teeth
The body and the moving pins are molded from thick plastic that does not rust on damp basement slabs. Wipe off drywall dust with a rag before you slide the tool back on the rack.
The spec line
| Tool shelf | Measuring and marking |
|---|---|
| Where it works | At the workbench, Around the house |
| Size | 10 in |
Payment, delivery and returns run at the storefront, under its own rules.
Others on the measuring and marking shelf
Miter Saw Protractor 7-Inch
An aluminum dial that takes the guesswork out of trim cuts by reading corner angles and showing the exact miter saw setting.
$24.994.7 out of 5 4,515 ratings
Woodworking Scriber T-Square
An aluminum rule and protractor head that locks down with a thumb nut for laying out lines, finding angles, and setting saw bevels across the bench.
$26.994.6 out of 5 1,215 ratings
Aluminium Scribing Tool
Mark uneven walls, scribe parallel lines, and trace tight arcs using an aluminum body that clips straight to your belt or pocket.
$29.994.4 out of 5 1,073 ratings
Contour Gauge Pair, 10-Inch and 5-Inch
Two gauges in two lengths to press against baseboard trim, copper supply lines, or wheel arches and transfer the line to your stock.
$29.994.6 out of 5 8,120 ratings