SAKER
Contour Gauge 10-Inch with Lock
A row of flat plastic teeth that presses against door casings, pipe curves, and uneven baseboards to lock the profile for a pencil trace.
$19.994.6 out of 5 22,735 ratings
3D Multi-Angle Square 8.5-Inch with Angle Pin
Setting out rafters or squaring a timber joint usually means shuffling two different rulers across the bench. We machined this block from anodized aluminum with scales etched along three faces so you wrap a line around corners without picking up the piece. The small indexing pin stores right in the frame when not set into a degree hole.
$29.994.2 out of 5 86 ratings
Price and stock live with the storefront and can move between visits.
2 versions of this bodySame tool, different kit or size. The spec line on each page carries what changed.
What this one is built to do
Three edge layout
Laser etched scales run across three faces of the aluminum body. You can scribe across the top face and down both sides of a board without lifting the square or losing your mark.
Hidden angle pin
The small indexing pin threads into the frame for storage. Pull it out and drop it into any preset angle hole to lock your angle against the edge of the stock.
Drill bit sizing holes
A row of gauge holes through the center lets you check drill bit sizes before you bore into good wood. It keeps you from digging through the bit index with calipers in hand.
Solid machined frame
We cut the entire body from aluminum alloy so it stays true when dropped on the shop floor. The anodized surface shrugs off moisture and keeps the etched lines readable in low bench light.
The spec line
| Tool shelf | Measuring and marking |
|---|---|
| Where it works | At the workbench |
| Size | 8.5 in |
Payment, delivery and returns run at the storefront, under its own rules.
Others on the measuring and marking shelf
Contour Gauge Pair, 10-Inch and 5-Inch
Two gauges in two lengths to press against baseboard trim, copper supply lines, or wheel arches and transfer the line to your stock.
$29.994.6 out of 5 8,120 ratings
Miter Saw Protractor 7-Inch
An aluminum dial that takes the guesswork out of trim cuts by reading corner angles and showing the exact miter saw setting.
$24.994.7 out of 5 4,515 ratings
Woodworking Scriber T-Square
An aluminum rule and protractor head that locks down with a thumb nut for laying out lines, finding angles, and setting saw bevels across the bench.
$26.994.6 out of 5 1,215 ratings
3D Multi-Angle Square 8.5-Inch with Angle Pin
Anodized aluminum layout square with three scaled edges and a hidden indexing pin for setting angles across your stock.
$29.994.2 out of 5 86 ratings