SAKER
Contour Gauge 10-Inch with Lock
A row of flat plastic teeth that presses against door casings, pipe curves, and uneven baseboards to lock the profile for a pencil trace.
$19.994.6 out of 5 22,735 ratings
3D Multi-Angle Measuring Square
A regular speed square stays flat on the stock, leaving you to roll the board to finish a line around the corner. We cut this one from anodized aluminum so the body wraps three sides in one pass. It carries an angle pin stowed inside the frame to lock preset stops without guessing your bevel.
$19.994.2 out of 5 86 ratings
Price and stock live with the storefront and can move between visits.
2 versions of this bodySame tool, different kit or size. The spec line on each page carries what changed.
What this one is built to do
Wraps three edges
The frame drops over the corner of your lumber, resting scales against three sides at the same time. You lay down a square crosscut line across the face and down the edges without moving the piece or realigning your pencil.
Stowed angle pin
The locating pin sits inside the body until you need a preset angle. Pull it out, drop it into the drilled stop, and run your pencil along the edge. The pin keeps the stop firm against the wood while you scribe.
Laser marked scales
We etch the inch markings directly into the anodized aluminum face so shop grit and sweat will not rub the numbers off. The edge lines sit crisp enough for a fine mechanical pencil lead to catch the groove for parallel scribing.
Drill sizing holes
A row of gauge holes down the center helps you check unlabeled twist bits before boring into a finished rail. You bring your own pencil and lumber; the square drops right into an apron pocket between cuts.
The spec line
| Tool shelf | Measuring and marking |
|---|---|
| Where it works | At the workbench |
Payment, delivery and returns run at the storefront, under its own rules.
Others on the measuring and marking shelf
Contour Gauge Pair, 10-Inch and 5-Inch
Two gauges in two lengths to press against baseboard trim, copper supply lines, or wheel arches and transfer the line to your stock.
$29.994.6 out of 5 8,120 ratings
Miter Saw Protractor 7-Inch
An aluminum dial that takes the guesswork out of trim cuts by reading corner angles and showing the exact miter saw setting.
$24.994.7 out of 5 4,515 ratings
Woodworking Scriber T-Square
An aluminum rule and protractor head that locks down with a thumb nut for laying out lines, finding angles, and setting saw bevels across the bench.
$26.994.6 out of 5 1,215 ratings
3D Multi-Angle Measuring Square
A machined aluminum layout square that wraps three faces of a board at once, holding preset angles and scribing lines without repeated flipping.
$19.994.2 out of 5 86 ratings